Midland XTC 400 Bedienungsanleitung PDF herunterladen (Seite 5)

5 midlandusa.com

Mounting and Aiming Your Camera

Mount on Dual Track System

The XTC400 was designed with an innovative 3 point mount system on

both sides and the bottom of the camera. This allows you to mount it on

any side with ease.

To mount the camera on the basic mount, slide the camera onto the

track system with the notches on the mount facing toward the back of

the camera.

To detach the camera from the mount, squeeze the mount release tabs

and slide the camera forward.

Aiming the Camera when mounted with the dual track mount:

When mounting the camera on a helmet, you must do the following:

1. Consider what you would like to shoot and mount the camera

accordingly- left side, right side or top.

2. Find a at surface and ensure the area is clean of dirt and debris.

Remove the cover of the adhesive pad and adhere to the helmet.

3. Once attached, adjust the camera to be sure you are lming in the

intended direction

4. If needed, rotate the lens to maintain an upright viewing angle

5. To see where your camera is aimed, enable Wi-Fi (pg 6) and use your

Android / IOS device with the app as a viewnder.

Mounting and Aiming Your Camera

Mount using the Thread Mount

On the bottom of the XTC400 is a standard thread mount that allows

the camera to be mounted to a tripod or other xture with a 1/4-20 (1/4”

diameter, 20 threads per inch) 5/16 deep thread. To attach the camera,

insert the screw on the mount into the camera thread and rotate the

camera clockwise to tighten down onto the screw.

Note: Over tightening may cause damage

to the mount and/or camera

Tripod Mount

Aiming the Camera when mounted with the thread mount:

When mounting the camera on a thread mount, follow these steps:

1. Consider what you would like to shoot and mount accordingly.

2. Ensure, once attached, that the camera is aimed straight and not toward

the ground or at the sky.

3. If needed, rotate the lens to maintain an upright viewing angle

4. To see where your camera is aimed, enable Wi-Fi (pg 6) and use your

smartphone with the app as a viewnder.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Keine Kommentare

Midland XTC 400 Bedienungsanleitung Seite 5